To make a High PDI Pellet:

1.  Charge all feed ingredients to blender.

2.  If possible, add Nutri-Binder® SUPER POWDER continuously while charging feed ingredients.
    If continuous addition is not possible, add Nutri-Binder® SUPER POWDER last  (on top of feed
    in blender).  NEVER ADD IN THE BOTTOM OF MIXER OR AS THE FIRST INGREDIENT - THIS WILL
    NOT GET MIXED PROPERLY.

3.  Mix for as long as possible in order to get the small concentration of Nutri-Binder® SUPER
    POWDER spread uniformly.  Each particle of feed ingredient needs to be coated with Nutri-
    Binder® SUPER POWDER.

4.  Activate with steam.  It takes temperature and moisture (steam or water) to activate
    Nutri-Binder® SUPER POWDER.  Run temperature as high as possible for best results.

    For 3/16" and 1/4" pellets, mill temperature should be 160°F or above.  For 3/8" and larger
    pellets, temperature should be 140°F or above.  Where possible, temperatures of 190-200°F
    are desirable - the higher the better.

    The use of steam enhancers will assist in achieving higher temperatures.  The earlier in the
    manufacturing cycle that steam activation can occur, the better. 

For information on IGP and/or our products E-Mail: info@industrialgrain.com
© 2000 Industrial Grain Products
Last modified: October 11, 2000